Monday, February 10, 2014
Hanging Lights
Shows some dimensions and inlay layout though im certain they are not totally accurate.
Other early cad versions .. I think the lamp should be roughly a little longer than the spot to spot dimension of the table to get the light over the whole surface.
The finished lamp with the other lamp in the background
Lamp over the table (+/- 30" above it in this instance ... I prefer them a little lower than this client did
Looking up .. commercial brass lamp parts purchased at the local lighting store .. Also not the copper heat shield spaced down an inch from the wood top. The wood top had slots to let the heat escape too .. I think in the end we used flood style bulbs ...
Ceiling support ... a simplified version of the ceiling plate on the light below, secured with round head screws
Our first hanging fixture, actually, coincidentally, over the dining table in a recent post about a table leaf. The lit panels are big leaf maple burl veneer on the outside, attached with 3m Spray 90, to plexiglass panels, held into rabbets with small brads
Looking up into that fixture ... four bulbs, hand blown and cut glass rondells, copper heat shield and slots in the fixture top .. It gives off a very warm funky light with interesting shadows from the rondells..
The whole fixture including the ceiling support and sconces we made in the background
this project was completed just as i was starting to do my own cad drawings. what i have assembled above here is all that i have, but with a little effort and imagination and picture staring, you can probably get a pretty good idea of the overall size of the hanging fixture ... top drawings with the hatched slots shows the cut outs for the heat to escape ... good luck
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment